Sales · Access and valve operation
Kluitmann Industrietechnik at CFT: keys and shaft tools
Between the crew and the valve there is almost always a key: the security lock on the shaft, the valve on the hydrant, the gate valve under the cap. Kluitmann Industrietechnik manufactures exactly this equipment – solid, precisely fitting and in the variants that actually occur out there.
View in the SEMPERDEAL online shop (external site) Advice +43 (0) 2252 53169
Kluitmann Industrietechnik product families
- SIGA security keys and tool holders
- Operating and turning keys
- HYDRA hydrant valve keys
- Hand tools for cable and utility shafts
The Kluitmann Industrietechnik range
SIGA security keys with tool holders for secured shafts, operating and turning keys for valves, HYDRA hydrant valve keys and hand tools for cable and utility shafts. Which key shape fits your locks is usually settled faster by a photo sent by e-mail than by any catalogue.
What these tools are used for
Our own crews stand in front of shafts and valves every day – with exactly these tools in the vehicle. What proves itself outdoors goes into our sales programme; what only looks good in the catalogue does not.
Service and replacement
Wear parts and replacements run through the group’s workshop service with a direct line to the manufacturer.
Frequently asked questions
How do I know which security key fits my shafts?
Most reliably from a photo of the lock – the systems differ in shape and depth. We match the picture against the range and name the fitting key.
Does CFT also supply custom-made keys?
Ask us: Kluitmann manufactures many variants, and the direct line to the manufacturer settles what is deliverable and what would be a special order.
Do the keys come with an introduction?
Hand tools need no instrument introduction – but they do come with a note on correct use. That is included with the purchase, by phone.
Kluitmann Industrietechnik in the SEMPERDEAL shop
Orders run through SEMPERDEAL, the group’s online shop – the advice comes from us.
We advise before you order.
Tell us what it is about – an instrument, accessories, a spare part or advice. We will tell you what these instruments can do.
What happens next
- We check whether the instrument fits your task – and tell you if it does not.
- You receive an offer including instruction; service and calibration where we hold the manufacturer’s authorisation.
- On request we demonstrate it on a real case beforehand.
Rather talk?
+43 (0) 2252 53169
Mon–Thu 8:00–16:30 · Fri 8:00–12:00
Which instrument fits your task?
We will tell you what these instruments can do – and what they cannot.
Outside office hours, write to office@cft.at.